Toshiba B-EX4 SERIES - Page 166

5. SYSTEM MODE EO18-33027
5.8 RAM CLEAR
5-70
5.8.1 NO RAM CLEAR
This option is provided for users who access this menu by mistake, and intended to exit from the RAM
clear menu without performing any RAM clear.
5.8.2 MAINTE.CNT CLEAR
The maintenance counter, including label distance covered, is cleared.
Initial value after maintenance counter clear
Item
Initial value
Label distance covered
0 km
Print distance
0 km
Cut count
0
Head up/down count
0
Ribbon motor drive time
0 hours
Head-up solenoid driver time
0 hours
RS-232C hardware error count
0
System error count
0
Momentary power interruption
count
0
Display
While clearing
After the maintenance counter clear is
completed
Turn off the printer when “COMPLETED. Turn off the printer” is displayed after the RAM clear is
completed.
5.8.3 PARAMETER CLEAR
The parameters settings are cleared.
Destination is selectable for parameter clear. The destination code printed on the top right corner of the
maintenance counter printout shows which destination was selected for the parameter clear.
Display
While clearing
After the parameter clear is completed