About this User Manual
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
4
1.4 Explanation of Symbols Used
The following symbols are used in these instructions:
DANGER!
DANGER indicates an immediately dangerous situation, with high risk, the death or severe
injury, if not avoided.
WARNING!
WARNING indicates a potentially dangerous situation with medium risk, the death or
severe injury, if not avoided.
ATTENTION!
ATTENTION indicates a situation that may lead to property damage, if it is not avoided.
NOTE
In NOTES you find tips, recommendations and important information. The notes facilitate
work, provide more information on specific actions and help to avoid overtime by not fol-
lowing the correct procedure.
CALL TO ACTION
This symbol identifies steps that the user has to perform.
RESULTS OF ACTION
This symbol identifies relevant results of steps.
1.5 Manufacturer and Service
Hans Turck GmbH & Co. KG
Witzlebenstraße 7
45472 Muelheim an der Ruhr
Germany
Turck supports you with your projects, from initia
l analysis to the commissioning of your applica-
tion. The Turck product database contains software tools for programming, configuration or com-
missioning, data sheets and CAD f
iles in numerous export formats. You can access the product data-
base at the following address:www.turck.en/products
Should you have any further questions, please contact the sales
and service team in Germany under
the following telephone numbers:
Sales: +49 208 4952-380
Technology: +49 208 4952-390
Internet: www.
turck.com/support
Outside Germany, please contact your local Turck representative.
To Next Page
Loading...
Need help?
General
