51
2018/02
TBPN-L1-FDIO1-2IOL- Safe I/O
8.1.8 Checking the Configuration
The Turck Safety Configurator checks the created configuration for logical errors, which meas, the
logical wiring of the single components in the release circuits is checked. The configuration check
does not consider double allocation etc.
Start the check using the "Check configur
ation" -button.
8.1.9 Loading the Configuration into the Safety Module.
Stop the safety module using the "Stop"-button.
Download the configuration creat
ed in the software to the device by using the button "Send
configuration” PC -> Monitor".
Fig. 23: Send configuration "PC->Monitor"
Enter the password for the configuration.
During the first download of a configuration to th
e device, the standard password "SIMON" has to
be changed.
HINWEIS
The default password for the safety module is "SIMON". If the device is reconfigured, a new
password has to be assigned. This password, must be known only to the responsible
authorized safety representative.
Change Password
Enter a new password for the application in the "Password dialog".
Fig. 24: Entering a new password.
To Next Page
Loading...
Need help?
General
