Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
2
3.8.4 Deleting the Memory Chip 25
3.8.5 Module Behavior and Configuration Transfer 26
4 Mounting 27
4.1 Mounting Material 27
4.2 Mounting the Device 27
4.3 Grounding the Device 28
4.3.1 Grounding the Device (FE) 29
5 Connecting 31
5.1 Connecting the M12 Connectors 31
5.1.1 Assuring Protection Class (IP67/IP69K) 31
5.2 Connecting the Devices to Ethernet 32
5.3 Connecting the Power Supply 33
5.3.1 24 V supply (PELV) 34
5.4 Connecting Sensors and Actuators 35
5.4.1 Switching Examples 36
6 Setting IP Addresses 37
6.1 Address setting via Rotary Coding Switches 38
6.2 State of Delivery 39
6.3 Setting the IP Address via the Web Server 40
6.3.1 Setting the IP Address for the Safety Side (last Byte) 41
6.4 Address Modes 41
6.4.1 Mode: BootP (300) 41
6.4.2 Mode: DHCP (400) 41
6.4.3 Mode: PGM (500) 42
6.4.4 Mode: PGM-DHCP (600) 42
6.4.5 Resetting the IP Address (Safety Side), Switch Position "000" 42
7 Commissioning 43
7.1 Initial Commissioning 43
7.1.1 Mounting and Electrical Installation 43
7.1.2 Setting the IP Address 43
7.1.3 Configuring in Turck Safety Configurator 44
7.1.4 Operation of the Device at the PLC 44
8 Configuring with Turck Safety Configurator
and Rockwell Studio 5000 45
8.0.1 Downloading the Software 45
8.0.2 Installing the Software 45
8.0.3 Licensing the Software 45
8.0.4 Starting the Software 45
8.0.5 Setting up a New Configuration 46
8.0.6 Adapting the Monitor Settings 46
8.0.7 Setting up a Standard Configuration 49
To Next Page
Loading...
Need help?
General
