Ultrasonix SonixTouch Q+ - 11.2.3 Operator Console; 11.2.4 Power Cord; 11.2.5 Barcode Reader; 11.2.6 Wireless Adapter (When Connected Externally)

SonixTouch Q+ Service Manual 00.053.204, Revision A Chapter 11: Maintenance
11-3
11.2.3 Operator Console
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth:
• water
• mild detergent (PH level at or near 7) and water solution.
11.2.4 Power Cord
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe the power cord:
• water
• mild detergent (PH level at or near 7) and water solution.
11.2.5 Barcode Reader
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe the barcode reader:
• water
• mild detergent (PH level at or near 7) and water solution.
11.2.6 Wireless Adapter (When Connected Externally)
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe the wireless adapter:
• water
• mild detergent (PH level at or near 7) and water solution.
11.2.7 SonixGPS Components
Cautions:
Power off and unplug the system prior to cleaning the operator console.
DO NOT apply cleaning solutions directly to the operator console.
Cautions:
Power off and unplug the system prior to cleaning.
DO NOT apply cleaning solutions directly to the power cord.
Warning: Disconnect the barcode reader prior to cleaning.
Caution: DO NOT apply cleaning solutions directly to the barcode reader.
Note: barcode reader usage should not entail patient contact.
Warning: Disconnect the wireless adapter prior to cleaning.
Caution: DO NOT apply cleaning solutions directly to the wireless adapter.
Note: Wireless adapter usage should not entail patient contact.
Warning: For details on SonixGPS cleaning and maintenance, refer to the most recent SonixGPS User
Manual.