SonixTouch Q+ Service Manual 00.053.204, Revision A Chapter 6: Peripherals and Accessories
6-7
6.6.1 Method 1: Via the TV’s HDMI or DVI Input
Search the TV manufacturer's user guide to determine whether or not the TV’s HDMI or DVI Input will accept the
required signal format.
Table 6-4: Required Signal Format
Determine the type of connector available on the TV in order to source the correct cable:
• DVI connection > DVI to DVI cable
• HDMI connection > HDMI to DVI cable.
To Connect the TV via the DVI Input:
1. With both the TV and the system powered off, connect one end of the DVI cable to DVI on the system’s Back
Connectivity Panel.
2. Connect the other end of the DVI cable to DVI Input on the TV.
3. Ensure the TV is plugged in.
4. Power on the TV.
5. Power on the system.
6. If necessary, once there is an image on the TV, configure the TV aspect ratio setting to 4:3 (not 16:9).
To Connect the TV via the HDMI Input:
1. With both the TV and the system powered off, connect the DVI end of the cable to DVI on the system’s Back
Connectivity Panel.
2. Connect the HDMI end of the cable to HDMI Input on the TV.
3. Ensure the TV is plugged in.
4. Power on the TV.
5. Power on the system.
6. If necessary, once there is an image on the TV, configure the TV aspect ratio setting to 4:3 (not 16:9).
Format Resolution V. Frequency
XGA 1024 x 768 60 Hz
To Next Page
Loading...
