SonixTouch Q+ Service Manual 00.053.204, Revision A Chapter 3: System Installation
3-5
3.2 PRE-INSTALLATION
3.2.1 Preliminary Inspection
During preliminary inspection, ensure the system crate was not tipped too far during transport and delivery.
Figure 3-1: Tip’n Tell Acceptable Unacceptable
To Inspect the Shipping Crate and Box Upon Arrival:
1. Examine the shipping container for any damage that may have occurred during transport.
2. Look for evidence to ensure that the crate has not been opened.
3. Examine the "Tip’n Tell" attachment on the outside of the package to ensure the crate has not been tipped too
far during transport and delivery (refer to Figure 3-1 for details).
4. Report any damage to both the carrier and Ultrasonix.
3.2.2 Unpacking Instructions
Equipment/Tools/Personnel Required:
• scissors or utility knife
• two people (recommended).
Note: Before unpacking the system, ensure there is adequate room for removing it from its packaging. The
space should be at least equivalent to the crate's overall dimensions.
To Next Page
Loading...
