Chapter 11: Maintenance 00.053.204, Revision A SonixTouch Q+ Service Manual
11-4
11.2.8 Transducer Holders and Cable Hooks
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe off the transducer holders and cable hooks:
• water
• mild detergent (PH level at or near 7) and water solution.
11.2.9 Footswitch (Dual and Triple)
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe off the footswitch:
• water
• 70% isopropyl alcohol.
11.2.10 Peripheral Tray and Basket
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe off the peripheral tray and basket:
• water
• mild detergent (PH level at or near 7) and water solution.
Cautions:
Power off and unplug the system prior to cleaning.
For best results, Ultrasonix recommends removing the transducer holders and cable hooks before cleaning (7.8.1).
This will allow the operator to clean all the various curves and folds in a more effective manner.
DO NOT apply cleaning solutions directly to the transducer holders and cable hooks.
Warning: Disconnect the footswitch prior to cleaning.
Caution: DO NOT apply cleaning solutions directly to the footswitch.
Note: Over time, silk-screened graphics may be damaged by the solvent effect of the isopropyl alcohol.
Cautions:
Power off and unplug the system prior to cleaning.
For best results, Ultrasonix recommends removing the peripheral tray basket before cleaning (7.8.2). This will
allow the operator to clean all the various curves and folds in a more effective manner.
DO NOT apply cleaning solutions directly to the peripheral tray basket.
To Next Page
Loading...
