Administration
A31003-S2030-M100-11-76A9, 01/2015
128 OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
administration.fm
Feature Configuration
3.7.2 Hot/Warm Phone
If the phone is configured as hot phone, the number specified in Hot warm destination is di-
aled immediately when the user goes off-hook. For this purpose, Hot warm phone must be set
to "Hot phone". If set to "Warm phone", the specified destination number is dialed after a delay
which is defined in Initial digit timer (seconds) (for details, see Section 3.7.3, “Initial Digit Tim-
er”). During the delay period, the user can dial a number which will be used instead of the hot/
warm destination. In addition, the user will be provided with a dial tone during the delay period.
With the setting "No action", hot phone or warm phone functionality is disabled.
Administration via WBM
System > Features > Configuration
Voice Mail number
Allow refuse
Hot/warm phone
Hot/warm destination
Initial digit timer (seconds)
Emergency number
Allow uaCSTA
Server features
Not used timeout (minutes)
Transfer on hangup
3335
Configuration
Recorder Address
Recording Mode
Audible Notification
Off
Disabled
Call Recording
Bluetooth
Audio
General
Bridging enabled
Dial plan enabled
FPK program timer
On
No action
30
5
Group pickup tone allowed
Group pickup as ringer
Group pickup visual alert
BLF alerting
Beep
Prompt
Enable Bluetooth interface
;
;
;
;
;
;
MWI LED
Key & AlertBar
MLPP ringer
Callback ringer
alert-internal
;
Submit
Reset
Missed call LED
Key only
Impact level ringer
To Next Page
Loading...
Need help?
General
