Administration
A31003-S2030-M100-11-76A9, 01/2015
152 OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
administration.fm
Free Programmable Keys
3.8.3 Repeat Dialing
On key press, the call number that has been dialed lastly is dialed again.
The label displayed to the left of the key is defined in Key label <key number>.
Administration via WBM
System > Features > Program keys > Repeat dialling
3.8.4 Call Forwarding (Standard)
This key function controls phone based call forwarding. If forwarding is enabled, the phone will
forward incoming calls to the predefined call number, depending on the current situation.
The label displayed to the left of the key is defined in Key label <key number>.
The Forwarding type parameter determines the forwarding behaviour. If "All callsUncondition-
al" is selected, any incoming call will be forwarded. If "On no reply" is set, the call will be for-
warded when the user has not answered within a specified timespan. The timespan is config-
ured in the WBM user pages under User > Configuration > Incoming calls > Forwarding > No
reply delay (seconds). If "On busy" is selected, incoming calls will be forwarded when the
phone is busy.
Administration via WBM
System > Features > Program keys > Forwarding
>
To use phone based call forwarding, Server features must be switched off (see Sec-
tion 3.7.10, “Server Based Features”).
>
This feature can be enabled or disabled under System > Features > Feature access
(see Section 3.6, “Feature Access”).
To Next Page
Loading...
Need help?
General