Administration
A31003-S2030-M100-11-76A9, 01/2015
204 OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
administration.fm
Distinctive RingingRinger Setting
3.14 Distinctive RingingRinger Setting
3.14.1 Distinctive
The SIP server may provide information indicating a specific type of call within an incoming call.
The phone can use this information to choose a ring tone according to the call type from the
"Distinctive ringer table".
The relevant information is carried as a string in the SIP Alert-Info header. This string is config-
ured in the OpenScape Voice system; please refer to the relevant OpenScape Voice documen-
tation. When the string sent via alert-info matches the string specified in the Name parameter,
the corresponding ringer is triggered. For instance, the OpenScape Voice system may send the
string Bellcore-dr1 to indicate that a call is from within the same business group, and the
Name parameter is set to "Bellcore-dr1". To select a specific ring tone for calls from the same
business group, the other parameters corresponding to that Name must be set accordingly.
The Ringer sound parameter determines whether a pattern, i. e. melody, or a specific sound
file shall be used as ringer.
Pattern melody selects the melody pattern that will be used if Ringer sound is set to "Pattern".
Pattern sequence determines the length for the melody pattern, and the interval between the
repetitions of the pattern. There are 3 variants:
• "1": 1 sec ON, 4 sec OFF
• "2": 1 sec ON, 2 sec OFF
• "3": 0.7 sec ON, 0.7 sec OFF, 0.7 sec ON, 3 sec OFF
The Duration parameter determines how long the phone will ring on an incoming call. The
range is 0-300 sec.
With the Audible parameter, the ringer can be muted. In this case, an incoming call will be in-
dicated only visually.
Special Ringers can be configured for the following call types:
• Internal
• External
• Recall
• Emergency
• Special1
• Special2
• Special3
To Next Page
Loading...
Need help?
General