To Next Page

To Previous Page

Startup

A31003-S2030-M100-11-76A9, 01/2015

28 OpenStage SIP V3R3 for OpenScape Voice, Administration Manual

inbetriebnahme.fm

Quick Start

2.3.6 SIP Server Address

The IP Address or hostname of the SIP server can be provided by DHCP.

The option’s name and code are as follows:

• option #120 "SIP Servers DHCP Option"

For manual configuration of the SIP server address see Section 3.5.6.1, “SIP Addresses”.

2.3.7 Extended Network Configuration

To have constant access to other subnets, you can enter a total of two more network destina-

tions. For each further domain/subnet you wish to use, first the IP address for the destination,

and then that of the router must be given. The option’s name and code are as follows:

• option #33 "Static Routing Table"

For manual configuration of specific/static routing see Section 3.3.6, “Specific IP Routing”.

Also the DNS domain wherein the phone is located can be specified by DHCP. The option’s

name and code are as follows:

• option #15 "Domain Name"

For manual configuration of the DNS domain name see Section 3.3.7.1, “DNS Domain Name”.

2.3.8 Vendor Specific: VLAN Discovery And DLS Address

If the phone is to be located in a VLAN (Virtual LAN), a VLAN ID must be assigned. In case the

VLAN shall be provided by DHCP, VLAN Discovery must be set to "DHCP" (see Section

3.2.2.2, “Automatic VLAN discovery using DHCP”).

If a DLS (Deployment Service) server is in use, its IP address must be provided. It is recom-

mended to configure the DLS server address by DCHP, as this method enables full Plug & Play:

having received the DLS address from DHCP, the phone will contact the DLS during startup.

Provided that the DLS is configured appropriately, it will send all necessary configuration data

to the phone. Additionally, this method is relevant to security, as it ensures the authenticity of

the DLS server.

For manual configuration of the DLS server address see Section 3.3.8, “Configuration & Up-

date Service (DLS)”.

For the configuration of vendor-specific settings by DHCP, there are two alternative methods:

1) the use of a vendor class, or 2) the use of DHCP option 43.

The VLAN ID can also be configured by LLDP-MED (see Section 3.2.2.2, “Automatic

VLAN discovery using DHCP”).

Unify OpenStage 15 Administration Manual

Other manuals for Unify OpenStage 15