Administration
A31003-S2030-M100-11-76A9, 01/2015
68 OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
administration.fm
IP Network Parameters
3.3.4 IP Address - Manual Configuration
3.3.4.1 Configuration
If not provided by DHCP dynamically, the phone’s IP address and subnet mask must be
specified manually.
By default, IP configuration by DHCP and LLDP-MED is enabled. For manual IP configuration,
please proceed as follows:
1. Navigate to Network > General IP configuration. Set DHCP Enabled, DHCPv6 Enabled
and LLDP-MED to "not selected". Afterwards, click Submit.
2. Navigate to Network > General IP configuration> IPv4 configuration or IPv6 configu-
ration depending on settings in Section 3.3.2, “Protocol Mode IPv4/IPv6”. Enter the IP ad-
dress and the Subnet mask. If applicable, enter the Default route. Afterwards, click Sub-
mit.
3. After the phone’s network service has restarted, the other IP parameters can be
configured.
>
IP addresses can be entered in the following formats:
– Decimal format. Example: 11.22.33.44 or 255.255.255.0 (no leading ze-
roes).
– Octal format. Example: 011.022.033.044 (leading zeroes must be used with
every address block)
– Hexadecimal format. Example: 0x11.0x22.0x33.0x44 (prefix 0x must be
used with every address block)