administration.fm
A31003-S2030-M100-11-76A9, 01/2015
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
87
Administration
Security
3.4.3 Security Log
A circular security log is used to capture important security specific events. It can be exported
as CSV data to an external application for analysis.
The Max. lines parameter defines the maximum number of entry lines that can be kept in the
security log before old entries are overwritten by new entries.
Archive to DLS controls whether the log is sent to the DLS. When activated, the DLS is used
to automatically archive the security log so that no log entries will be lost.
With Archive when at, the trigger for log archiving is set. Automatic archiving of new security
log entries will occur when the percentage of unarchived entries in the log is as specified or
more. When set to disabled, every new entry will trigger a save (only possible via DLS). The
possible values are "10%”, ”20%”, ”30%”, ”35%”, ”40%”, ”45%”, ”50%”, ”55%”, ”60%”, ”65%”,
”70%”, ”80%”, ”90%”.
The security log upload may be accomplished in two ways:
• If "Archive to DLS" is enabled, if the security log reaches the threshold % for unachieved
entries, the phone will initiate an upload.
• If "Archive to DLS" is NOT enabled and the security log reaches the threshold % for un-
achieved entries, the phone only sets the "archive-me" flag, it does not initiate the a r c h i v e .
It is up to the DLS to recognize the flag and initiate an upload.
Last archived shows the date when the security log was last archived to the DLS.
Administration via WBM
System > Security > Logging
>
The security log cannot be disabled.
To Next Page
Loading...
Need help?
General
