6. To activate the new configuration, reset the QML data logger. Select Maintenance >
Reset > Immediate.
5.13 FS11 Maintenance
For information on FS11 maintenance, see Vaisala Visibility Sensor FS11 User's Guide.
5.13.1 Adding FS11 to System
Before configuring the new sensor, complete the mechanical installation.
1. In AWS Client, select Settings > Parameters > Static.
2. In the CFG parameter set, select Visibility.
3. To enable the sensor, type 1 in the Value
field, and select Save.
4. To activate the new
configuration, reset the QML data logger. Select Maintenance >
Reset > Immediate.
5.14 PWD22 Maintenance
For information on PWD22 maintenance, see Vaisala Present Weather Detector PWD22/52
User's Guide.
5.14.1
Adding PWD22 to System
Before configuring the new sensor, complete the mechanical installation.
1. In AWS Client, select Settings > Parameters > Static.
2. In the CFG parameter set, select Visibility.
3. To enable the sensor, type 1 in the Value field, and select Save.
4. To activate the new
configuration, reset the QML data logger. Select Maintenance >
Reset > Immediate.
5.15
CL31 Maintenance
For information on CL31 maintenance, see Vaisala Ceilometer CL31 User Guide.
5.15.1
Adding CL31 to System
Before configuring the new sensor, complete the mechanical installation.
1. In AWS Client, select Settings > Parameters > Static.
2. In the CFG parameter set, select CL31.
3. To enable the sensor, type 1 in the Value
field, and select Save.
Chapter 5 – Maintenance
111
To Next Page
Loading...
