2. Open the General Settings parameter set.
3. To change the value of a parameter, select the parameter and Edit.
4. In Value, type the new value.
If Save is grayed out, the value is invalid.
5. To save the changes, select Save.
6. To close the window, select Close.
4.4.3
Setting Location Parameters
If you use the sunshine duration calculation, add the geographical coordinates of the
observation site.
1. In AWS Client, select Settings > Parameters > Static.
2. Open the General Settings parameter set.
3. Select the Latitude parameter.
4. In Value, type a new value.
The value must be −90 ... 90°.
5. To save the changes, select Save.
6. Repeat the procedure for the Longitude parameter.
The value must be −180 ... 180°.
AWS310-SITE Configuration and Maintenance Manual M211828EN-C
36
To Next Page
Loading...
