2. Detach the negative ( ˗ ) cable from the battery, and make sure that the cables do not
touch each other.
1 Hex screw
2 Flat cable connector
3 Battery terminal
4 Washer
5 Spring washer
6 Hex nut
3. Detach the positive ( + ) cable from the battery.
4. Remove the mounting clamp and then the battery from the holder.
5. Install the new battery.
6. Reconnect cabling in reverse order: positive ( + ) cable
first.
7. Switch the power back on and check that the new battery works properly.
5.6.5
Replacing AC/DC Power Supply Unit
Slothead screwdriver
Only licensed experts may install electrical components. They must
adhere to local and state legislation and regulations.
WARNING!
Chapter 5 – Maintenance
91
To Next Page
Loading...
