1 Altitude = Ground level from mean sea level in meters
2 Pressure sensor level = Distance between the bottom flange of the enclosure and
the ground
3. To save the changes, select Save.
4.4.2
 Setting Station Parameters
The dierent station options are controlled by station settings, also known as static
parameters, which are grouped into parameter sets.
All the parameters are automatically created on the QML data logger when the setup is
uploaded.
Check that the parameter values represent the actual conditions at each station. If needed,
change the value.
Do not change values that are not instructed to be changed in this manual or by Vaisala
personnel. Take special care when updating the parameters over a remote connection, as
incorrect values may cause you to lose the remote connection to the station.
1. In AWS Client, select Settings > Parameters > Static.
Chapter 4 – AWS Client Usage
35
To Next Page
Loading...
