5. Clear the active warnings.
/ W> warnings clear
6.6.3 Checking System Information
To acquire a report that contains system information, use the sysinfo command. The
command lists parameters that are especially useful when troubleshooting the system or
when contacting Vaisala technical support.
Example of sysinfo output:
/W > sysinfo
Serial # : N1415053
Hardware : QML201C-003
Software : 8.05f
Checksum : 9F4EC82B
Boot sw version : 8.00
Program flash : 4096kB
System RAM : 2048kB
Free memory : 963kB
Internal temp. : 24.94'C
Active errors : NO
Active warnings : YES
Piggyback - 0 : DSI486 rev: E serial no: 621115
Piggyback - 1 : DSI486 rev: E serial no: 611504
Setup file : /Cfg/AWSSITE.adc
Setup for sw : 8.05
Setup creator : Vaisala
Setup created : 2017-12-14T08:54:37+00:00
Setup info : v1.00
Setup CRC : EDED60B9
Lizard version : 9.05
System uptime : 65h 29min 45sec since Fri Dec 15 23:44:39 2017
Table 31 Contents of
sysinfo Command Output
Parameter Explanation
Serial #
Serial number of the PCB of the QML data logger.
Hardware
Hardware revision of the PCB of the QML data logger.
Software
Operating software version of the QML data logger and checksum.
Boot sw version
Boot software version of the QML data logger.
Program flash
Total amount of program memory.
System RAM
Total amount of memory on the QML data logger.
Chapter 6 – Troubleshooting
131
To Next Page
Loading...
