Example of LLWAS Report
$PAMWV,60,R,11.0,M,A*1D<CR><LF><SOH>STA<STX> 12.0 0 28.8 1<ETX><CR><LF>
4.12 Reading Fixed Display QMD202
The optional local fixed display QMD202 provides views for instant measurements and basic
system information. QMD202 is located inside the enclosure. To navigate between the views,
press the buttons on the display.
If you have reset the QML data logger, wait until the reset is complete and the setup is
running without problems before switching on the display. When the logger is ready for
use again, the AWS Client terminal window displays the text Setup running ok. You
can use the LED indicator to determine the operation mode of the QML logger.
In addition to measured values, most of the display screens contain the corresponding
sensor status, usually in the rightmost column:
• 0 = Observation status is OK
• Other than 0 = Observation status is not OK or has some other status
More Information
‣
Determining QML Data Logger Operation Mode (page 120)
‣
Sensor Status Values (page 149)
4.12.1
Meteorological Display 1
Table 16 Parameters of Meteorological Display 1
Observation Explanation Unit Statistic Period
TA Air temperature °C Instant value from sensor 10 s
RH Relative humidity % Instant value from sensor 10 s
PA Barometric pressure hPa Instant value from sensor 60 s
Chapter 4 – AWS Client Usage
79
To Next Page
Loading...
