5. In problem situations, give the following commands.
• errors
• spset
• sysinfo
• warnings
6. When you have recorded enough text, clear the Trace log on option.
Never leave the Trace log on option on for a longer period of time. The accumulated
log files consume disk space.
7. When you no longer need the generated trace log files, delete them from your
computer.
6.5.6
Problem Situations with QML Data Logger
The instructions assume that the person who is troubleshooting the QML data logger has
experience in operating a weather station.
Table 29 QML data logger Problem Situations and Their Remedies
Problem Probable Cause Remedy
Any technical problem
with the QML data logger.
Vandalism. 1. Check the cabling and mechanical structure
visually.
2. Check that all the connectors are properly
attached.
See Enclosure Maintenance (page 86).
Lightning strike damage.
Other visible cause.
Software or hardware
changes were made to
the station prior to
malfunctioning.
When you have loaded a new setup:
1. Make sure you have the original setup and the new
setup saved as an .adc file.
2. Reload the original setup and verify that the
system starts and runs with the original setup.
When you have installed new hardware:
1. Disconnect the new hardware.
2. Reload the original setup and verify that the
system starts and runs.
3. Connect the new hardware.
4. Reload the new setup and verify that the system
starts and runs.
System is non-functional. Backup batteries are
empty.
1. Check if the green LED on the QML data logger is
blinking. See Determining QML Data Logger
Operation Mode (page 120)
2. If not, check if there is sucient voltage (8 ... 16
VDC) present in the +ExtDC input of the logger.
No AC (mains) power.
System has been
damaged due to a power
surge.
AWS310-SITE Configuration and Maintenance Manual M211828EN-C
124
To Next Page
Loading...
