6.6.2 Checking Warnings
The / W> prompt in the terminal window means that there are warnings. Warnings indicate
that there are some problems in the software. It is normal to see one or two warnings after
resetting the serial connection to the QML data logger. For example, if you have turned your
computer o, you can ignore these warnings.
1. Check the active warnings.
/ W> warnings
Example output:
Warning: Break
occurred 9 times first in uart.cpp[84]
during thread: 00019F60 [AbsTimerT]
object pointer: 106C [component: COM0]
Warning: Frame
occurred 14 times first in uart.cpp[83]
during thread: 00019F60 [AbsTimerT]
object pointer: 106C [component: COM0]
2. The Break and Frame warnings most likely mean that you have turned your computer
o and on again. You can clear these warnings.
3. The following warning means that you have reset the QML data logger. You can clear
this warning. If you have not reset the QML data logger and the warning still occurs,
contact Vaisala technical support.
Warning: Device reset
occurred 1 times first in c:/libs/MAWS/adcl/kernel/idle.cpp[52]
during thread: 00001694 [Idle]
object pointer: 163C [component: Idle]
4. If you receive the following warning, check that the parameters sname, pslevel, and
altitude are set.
Warning: Data missing
occurred 2 times first in h:/MAWS/software/adcl/report/confrep.cpp[414]
during thread: 00019C0C [AbsTimerT]
object pointer: 33A94 [component: MyRep1]
AWS310-SITE Configuration and Maintenance Manual M211828EN-C
130
To Next Page
Loading...
