Vaisala AWS310-SITE - Page 146

Command Syntax Description
spset [parameter] [value] spset shows a list of static parameters.
spset parameter value sets the given value to the given static
parameter.
This command is not usually needed.
spval [parameter] [value] Shows information on the given parameter type:
• I = Integer
• R = Real
• S = String
• B = Byte array
• Number
field with the parameter status value in hexadecimal
Can also be used to set the static parameter value (see spset).
sysinfo [sensors|ports] sysinfo shows a summary of system information.
sysinfo sensors shows system information on system sensors.
sysinfo ports shows the system information output and information
on communication module ports.
time [HH MM SS YY MM DD] time shows the current time.
time HH MM SS changes the current time. For example: time 14 10 00
time HH MM SS YY MM DD changes the current date. For example:
time 14 10 00 98 12 31
timezone [hours] timezone shows the time zone.
timezone hours defines the time dierence from UTC and sets a new
time zone. For example: timezone 2
userlevel [level <set|
clear>]
Protects the system from unauthorized use. The command provides
3 password protected access levels to shell commands, as well as to the
visibility of system data. By default, the user levels are not in use.
verify <source_file>
[destination_file]
Compares two files. If they are dierent, the response is:
Error: Files are different
warnings [clear] warnings shows the active warnings. Warnings indicate that there are
some problems in the software.
warnings clear clears the active warnings.
zr
[rectimeout <time_in_ms>]
Zmodem command for transferring the setup file to the QML data logger
(used instead of the AWS Client function).
zs <filename> Zmodem command for sending a file from the QML data logger (used
instead of the AWS Client function).
AWS310-SITE Configuration and Maintenance Manual M211828EN-C
144