3. From the Type list, select Serial Port.
4. In Common, set the following:
Name
Type an alphanumeric string that uniquely identifies the connection that you
create in the address book.
Station id
If you have only one weather station in the network, you can leave the field blank.
If you have multiple weather stations in the same network, and you are going to
access them over the same connection, type an alphanumeric string that uniquely
identifies the station for which you are creating an address book entry.
Command wait timeout (ms)
Type a value in milliseconds that specifies how long AWS Client waits for the QML
data logger to respond when AWS Client sends a request over the connection.
The value should be at least 20000 ms (20 s).
If the request, for instance, a log file download, succeeds within the timeout, a
success message is displayed. If the request fails, a failure message is displayed
instead, and you can try again at a later time.
Factors such as the current load on the QML data logger, delays in the
connection, and the response length
aect whether or not the timeout expires
during a request.
AWS310-SITE Configuration and Maintenance Manual M211828EN-C
30
To Next Page
Loading...
