82 © Vbrick Systems, Inc.
Multi Server Max.
Throughput
Maximum amount of bandwidth used by streaming clients within
the Multi Protocol Server. This includes RTP/RTSP/RTMP/
RTMFP/Vbrick Multicase. This number is capped by the
appropriate DME license, but can be set lower to limit the actual
max bandwidth used.
Defaults (7530/7550/7570): 100Mb/500Mb/3072Mb
RTP Buffer Length
(seconds)
The maximum time a packet will sit in a streaming buffer before
being delivered to the client. This is adjusted for poor quality
networks between client and server. Lower numbers may reduce
playback latency. The higher number allows it to behave better
with poor network connections.
Defaults (7530/7550/7570): 10/10/10
RTCP Timeout
(seconds)
The maximum time the DME will wait for a RTP server will wait
before timing out the connection. Setting a value of 0 means never
timeout. This is useful if the source is not sending any RTCP
reports. Also, when using Pause in a RTP player, this number is
what the server will wait as a maximum before terminating the
paused connections. Setting it to 360 will allow a maximum pause
of 5 minutes. It also means it will wait up to 5 minutes to drop
connections that do not terminate gracefully, including live
content, where the stream is interrupted.
Defaults (7530/7550/7570): 15/15/15.
Default Authentication
Scheme
• Basic – the DME server sends authentication credentials over
the network in Base64 encoded text.
• Digest – the DME server sends encrypted authentication using
MD5 credentials over the network.
Defaults (7530/7550/7570): digest/digest/digest
Field Description
To Next Page
Loading...
General