VIDEOJET DataFlex 6530 - Page 128

Videojet DataFlex 6530 Service Manual - Rev AA B-5
<<ACK<CR>
Updates variable fields on the current job; sets the field “Line 1” to the value “First Line” and the
field “Line 4” to the value “Fourth Line”.
The Print Command (PRN)
This command causes the currently selected job to be printed once.
Syntax
PRN<CR>
Return Values
On success, it returns the default success response. On failure, it returns the default failure
response. If the command succeeds, the response is sent after the job has been printed.
Details
The PRN command attempts to print the current job.
Examples
>>PRN<CR>
<<ACK<CR>
The current job was successfully printed.
The Set State Command (SST)
This command attempts to set the overall state of the printer.
Syntax
SST|<desiredstate>|<CR>
Return Values
On success, returns the default success response. On failure, returns the default failure response.
If the command succeeds, the response is sent after the state transition has taken place.
Details
The SST command attempts to set the overall state. Valid values for desired state are:
•Shut down
•Starting up
• Shutting down
• Running
• Offline
The most likely reason for a failure on this command is trying to perform a state transition which
is not supported. Please refer Figure B-1 for the permitted state transitions in CLARiTY.