VIDEOJET DataFlex 6530 - 1.6 Chapters in the Manual

Videojet DataFlex 6530 Service Manual - Rev AA 1-5
Introduction
1.6 Chapters in the Manual
This manual is divided into fifteen chapters. An introduction to the topics that each chapter
covers is shown in Table 1-3.
Chapter No. Chapter Name Description
1 Introduction Contains the information about this manual, the related 
publications, and writing styles used in this manual.
2 Safety Contains the safety and hazard information.
3 Main Parts Describes the main parts of the printer.
4 Installation Contains the information about installation of the main
components of the printer.
5CLARiTY
Operating System
Contains the information about CLARiTY operating
system.
6Replacement
Instructions
Explains the procedures to remove and replace the parts
of the printer.
7 Maintenance Contains the information on service and maintenance.
8 Troubleshooting Contains the service level diagnostic and troubleshooting 
procedures.
9 Illustrated Parts
List
Contains the illustrated parts list of orderable parts.
Appendix A Menu Structure Contains the menu structure of the CLARiTY 
Configuration Manager.
Appendix B External Serial
Interface
Contains information about the communication protocols 
followed by the printer.
Appendix C Test Points Contains informations about Mains board test points.
Appendix D Theory of
Printing
Contains the theory of printing.
Appendix E Master Slave
Setup
Contains information about master/slave setup.
Appendix F Availability Contains information about availability tools.
Table 1-3: List of Chapters