VIDEOJET DataFlex 6530 - Section 7 Maintenance; 7.1 General Maintenance

Videojet DataFlex 6530 Service Manual - Rev AA 7-1
Section 7 Maintenance
7.1 General Maintenance
Videojet DataFlex 6530 requires minimum ongoing maintenance.
Note: Harsh or dirty environments may require shorter intervals between preventive maintenance
routines.
Do the following inspections and perform the measures as per the scheduled frequency.
Refer to operator manual for detailed procedure on cleaning the printhead and lightbox.
CAUTION
EQUIPMENT DAMAGE.
The use of an incompatible cleaning kit can seriously damage your printer. Such damage will
not be covered by your printer warranty. Use only cleaning kits approved by your dealer.
Inspection Check Point Frequency Measures
CLARiTY Display
Check if the touch screen is
clean
As Required Clean the touch screen by wiping
with a dry soft cloth or cotton pad.
Printhead
Printhead With every ribbon
change (minimum
frequency)
Note: Harsh or dirty 
environments may
require shorter intervals
between cleaning
Clean with pre-soaked swabs or
wipes that are available from the
approved cleaning kits. For more
information on cleaning the 
printhead.
Refer to Operator manual for more
information.
Lightbox With every ribbon
change (minimum
frequency)
Note: Harsh or dirty 
environments may
require shorter intervals
between cleaning
Clean with pre-soaked swabs or
wipes that are available from the
approved cleaning kits. For more
information on cleaning the 
printhead.
Refer to Operator manual for more
information.
Peel Roller As required (for 
example, when ink has
transferred to the roller)
Clean with pre-soaked swabs or
wipes that are available from the
approved cleaning kits.
Cable
Check all screw-fastened 
plug-and-socket
connectors for tight fit.
As Required If necessary, re-tighten them.
Table 7-1: General Maintenance Schedule