4-16 Videojet DataFlex 6530 Service Manual - Rev AA
Installation
7. Select OK after confirming that the correct archive has been selected.
8. Close the CLARiTY Configuration Manager software.
9. Remove the USB memory stick from the computer.
4.7.8.3 Restoring the Archive to the Printer
Do the following tasks to restore the archive to the printer:
1. Insert the USB memory stick containing the desired archive into the printer’s USB port.
2. Navigate to Tools > Setup > Control > CLARiTY Parameter Archives (Figure 4-14 on page 4-14).
3. Locate the desired archive from the list on the screen and select it.
4. Select the Restore Archive button at the bottom of the screen.
5. Select Yes if you are sure that you want to continue with the restore process after reading the
message on the printer’s screen.
6. Select Yes or No depending on whether or not you want to restore the network settings from
the archive.
7. Select Yes or No depending on whether or not you want to restore the password settings
from the archive.
8. Once the screen indicates the Archive was restored successfully, press OK.
Figure 4-17: Confirm Archive Replacement
To Next Page
Loading...
