VIDEOJET DataFlex 6530 - 2.4 Installation of the Printer

2-4 Videojet DataFlex 6530 Service Manual - Rev AA
Safety
2.4 Installation of the Printer
Hazardous locations, as defined in the United States, are those areas that may contain hazardous
materials in a quantity sufficient to create an explosion. These are defined in Article 500 of the
National Electrical Code
ANSI/NFPA 70–1993.
Outside United States, you must ensure compliance with all local regulations regarding the
equipment placement in potentially hazardous locations.
Using Printer Accessories
To maintain regulatory approval for the printer, use only Videojet approved accessories when
attaching any device to the equipment.
CAUTION
PERSONAL INJURY.
Do not unplug any connector on the equipment when the mains power is on (except USB and
ethernet cables).
WARNING
PERSONAL INJURY.
The printer uses an operator control console. Ensure that this panel is mounted at an
appropriate working height and orientation for ease of operation.
WARNING
PERSONAL INJURY.
Do not place the printer in a hazardous location. Hazardous locations might create an
explosion, leading to personal injury.
WARNING
PERSONAL INJURY.
Place the printer so that no access to the print mechanism is possible after installation.
WARNING
PERSONAL INJURY.
Do not remove the side covers from the printer after installation.