WEG CFW-09 - Page 278

279
CHAPTER 8 - CFW-09 OPTIONS AND ACCESSORIES
3.
Press the board near to XC140 and on the lower right edge until the
connector and the plastic spacer is inserted completely.
4.
Fix theboard to themetallic spacer through the bolt (except ModBus RTU).
5.
FieldbusConnector:
Sizes 1 and 2 (Models up to 28 A):
-
Fix the Fieldbus connector to the inverter frame by using the 150mm (5.9 in)
cable (refer to figure 8.36).
Figure 8.36
- Fastening of the Fieldbus connector