WEG CFW-09 - P022 weg Use

121
CHAPTER 6 - DETAILED PARAMETER DESCRIPTION
Range
[Factory Setting]
Parameter
Unit
Description / Notes
Indicatesthenumbersofthelast,second,third andfourthprevious Faults.
Fault Sequence:
Exy

P014

P015

P016

P017

P060

P061

P062

P063

P064

P065.
Ex: When the display shows 0 (zero), this means E00, 1 (one) means
E01 and so on.
P014
0 to 71
Last Fault
[ - ]
-
P015
0 to 71
Second Previous Fault
[ - ]
-
P016
0 to 71
Third Previous Fault
[ - ]
-
P017
0 to 71
Fourth Previous Fault
[ - ]
-
P018
-100 to +100
AnalogInputAI1'Value
[ - ]
0.1 %
P019
-100 to +100
AnalogInputAI2'Value
[ - ]
0.1 %
P020
-100 to +100
AnalogInputAI3'Value
[ - ]
0.1 %
P021
-100 to +100
AnalogInputAI4'Value
[ - ]
0.1 %
Indicate the percentage value of the analog inputs AI1 to AI4. The
indicated values are obtained after offset action and multiplication bythe
gain. Refer to parameters P234 to P247.
P022
-
WEG Use
[ - ]
-
P023
V4.0X
Software Version
[ - ]
-
Indicates the CFW-09 Software Version.
P024
LCD:-32768
A/DConversion
to +32767
ValueofAnalog
LED: 0 to FFFFH
Input AI4
[ - ]
-
Indicates the A/D conversion result of the analog input A14 located on
the I/O Expansion Board.
The LCD display indicates the conversion value as a decimal number
and the LED display as a hexadecimal number with negative values in
supplement of 2.
P025
0 to 1023
A/DConversion
[ - ]
Valueof IvCurrent
-
P026
0 to 1023
A/DConversion
[ - ]
Value of Iw Current
-
P025 and P026 indicate the A/D conversion result, in module, of the V
and W phase currents, respectively.