WEG CFW-09 - Default Chapter; Table of Contents

Summary
Quick Parameter Reference, Fault and Status Messages
I.
Parameters
.......................................................................................
09
II.
Fault Messages
....................................................................................
33
III. Other Messages
.................................................................................
34
CHAPTER
1
Safety Notices
1.1 Safety Notices in the Manual
.............................................................
35
1.2 Safety Notices on the Product
...........................................................
35
1.3 Preliminary Recommendations
..........................................................
35
CHAPTER
2
General Information
2.1 About this Manual
..............................................................................
37
2.2 Software Version
................................................................................
37
2.3About the CFW-09
.............................................................................
37
2.4 CFW-09 Identification Label and Code Number
..................................
39
2.5Receiving and Storage
.......................................................................
41
CHAPTER
3
Installation and Connection
3.1 Mechanical Installation
......................................................................
42
3.1.1 Environment Conditions
...............................................................
42
3.1.2 Dimensional of CFW-09
...............................................................
42
3.1.3 Mounting Specifications
...............................................................
43
3.1.3.1 Mounting Inside a Panel
.....................................................
44
3.1.3.2Mounting on Surface
..........................................................
45
3.1.3.3 Mounting with the Heatsink Through a Surface
..................
46
3.1.4 Keypad (HMI) and CoverRemoval
................................................
48
3.2 Electrical Installation
..........................................................................
49
3.2.1 Power/Grounding Terminals
.........................................................
49
3.2.2 Location of the Power/Grounding/Control Connections
................
51
3.2.3 Rated Voltage Selection
..............................................................
53
3.2.4
Power/Grounding Wiring andFuses
............................................
54
3.2.5
Power Connections
.....................................................................
57
3.2.5.1AC Input Connection
...........................................................
57
3.2.5.2 Output Connections
............................................................
58
3.2.5.3 Grounding Connections
.......................................................
58
3.2.5.4 IT Networks
.........................................................................
59
3.2.6
ControlWiring
..............................................................................
61
3.2.7
Typical Terminal Connections
......................................................
64
3.3 European EMC Directive - Requirements for Conforming Installations
67
3.3.1 Installation
...................................................................................
67
3.3.2 Epcos Filters
...............................................................................
68
3.3.3 Schaffner Filters
...........................................................................
71
3.3.4 EMC Filter Characteristics
...........................................................
74