WEG CFW-09 - Page 279

280
CHAPTER 8 - CFW-09 OPTIONS AND ACCESSORIES
Figure 8.37
- Fastening of the Fieldbus connector
Figure 8.38
- Connection to the Fieldbus board
6.
Connect the other cable end of the Fieldbus connector to the electronic
Fieldbus board, as shown in figure 8.38.
DEVICENET
PROFIBUS DP
Sizes 3 to 10 - (models up to 30 A):
-
Connect the Fieldbus connector to the metallic “L” by using the 150 mm
(5.9 in).
-
Fasten the set to the metallic support plate of the control board (refer to
figure8.37).