Maintenance
2751−1/A1
Winterthur Gas & Diesel Ltd.
7/ 8
5. Elastic Studs − Replace
1) Use the stud tool (94008A−M12,
Fig. 12) to remove the elastic stud (1).
2) Remove all grease and clean the
sealing face of the new elastic stud.
3) Read the data in the documentation of
the jointing compound manufacturer. If
necessary, apply adhesive primer to
make the adhesion on the joint surface
better.
4) For the recommended jointing
compounds and adhesive primers, see
the Table 1.
Note: Do not apply adhesive primer or
lubricant to the thread of the
elastic stud (1).
5) Put the elastic stud (1) into the
applicable position.
6) Tighten the elastic stud (1), refer to the
instructions given in 0352−2,
paragraph 2.
Note: Read the data in the documentation of the manufacturer to mix and apply
the jointing compounds.
Table 1: Jointing Compounds and Hardeners
Jointing
Compound
Hardener Adhesive
Primer
Manufacturer
Elastosil
RT 622 A
RT 622 B G 790 Wacker-Chemie Gmbh
Geschäftsbereich Silicone
Hanns-Seidel-Platz 4
D-81737 München
Silcoset
105 RTV
Silcoset
Curing Agent A
Silcoset Primer AMBERSIL LTD
Wylds Rd
Bridgwater
Somerset
TA6 4DD
England
2016
Removal and Installation of Exhaust Valve, Replacement of Elastic Studs
94008A−M12
WCH00836
003.465/00
JOINTING
COMPOUND
1
SEALING
SURFACE
Fig. 12
To Next Page
Loading...