Xerox 8850 Service Manual

03/2003
6-32
8850/ 510DP
Installation Procedure
General Procedures
27. (Figure 21): Check the level of the Printer.
Figure 21 Checking the front-to-rear Printer level
28. Repeat the Printer leveling (Steps 23 through 27) until the Printer is level.
29. Lock the Printer casters.
30. Close the top cover.
31. 8850: Close the rear door and tighten the locking screws(2). SPS 510dp: Close and latch
the rear door.
32. Install a roll of 36 inch (A0) Bond media in Roll 1 Media Supply Drawer. Refer to the User
Guide as required.
NOTE: If the 510dp or an HFT Controller is being installed, continue with Step 33. if not,
proceed with Step 34.
33. (Figure 22 ): HFT Conroller: Install the P193 Interface Cover, then continue with Step 35.
Figure 22 Installing the P193 Cover to Connect the HFT Controller
34. Refer to the appropriate AccXES Controller Service Manual, 8825. 8830. and 8850 Con-
troller Installation to install the Controller.
35. Prepare to install the Printer Power Cord.
a. (Figure 27): Loosen the retaining screw on the Power Cord bracket.
Place the level on the
metal edge of the devel-
oper module and check
the front-to-rear level of
the Printer.
1
Connect the ribbon
cable to P/J 610
2
Install the Cover

Xerox 8850 Specifications

General

Brand	Xerox
Model	8850
Category	Printer
Language	English