Error Messages and Codes 3-65
Y2T Tray 4 media size sensor unexpectedly activated while transfixing the print.
Y2V Tray 4 media size sensor unexpectedly activated while the system drum
maintenance cycle was being performed.
Y2W Tray 4 media size sensor unexpectedly activated while system imaging.
Y2X Tray 4 media size sensor unexpectedly activated while exiting print.
1. Ensure ground integrity of the system (see page 4-73).
2. Ensure the paper guides are correctly set.
3. Run the Monitor Sensors test to test the media size sensor.
4. Replace the Tray 4 525-Sheet Feeder.
5. Replace the pivot arm.
Z2A Tray 4 pick flag triggered unexpectedly during abnormal shutdown.
Z2B Tray 4 pick flag triggered unexpectedly during normal shutdown.
Z2C Tray 4 Pick flag triggered unexpectedly during mechanical recovery.
Z2D Tray 4 pick flag triggered unexpectedly during warm-up.
Z2E Tray 4 pick flag triggered unexpectedly while system ready.
Z2F Tray 4 pick flag triggered unexpectedly while system in fault state.
Z2L Tray 4 pick flag triggered unexpectedly while system in standby.
Z2M Tray 4 pick flag triggered unexpectedly while pick from Tray 2.
Z2N Tray 4 pick flag triggered unexpectedly while pick from Tray 4.
Z2P Tray 4 pick flag triggered unexpectedly while pick from Tray 4.
Z2Q Tray 4 pick flag triggered unexpectedly while pick from Tray 1.
Z2x (continued)
Z2R Tray 4 pick flag triggered unexpectedly while duplexing.
Z2S Tray 4 pick flag triggered unexpectedly while paper staged for print.
Z2T Tray 4 pick flag triggered unexpectedly while transfixing the print.
Z2V Tray 4 pick flag triggered unexpectedly while the system drum maintenance cycle
was being performed.
Z2W Tray 4 pick flag triggered unexpectedly during system imaging.
Jam Code Troubleshooting Procedures (Continued)
To Next Page
Loading...
Need help?
General