377
When M0 is from OFF→ON, run ‘PLSR HD0 HD100 K1 Y0’ in the BLOCK to output the
pulse;
When M1 is from OFF→ON, suspend running the BLOCK, the pulse will stop slowly with
slope;
When M3 is from OFF→ON, output the rest pulses.
Please note that by the SBSTOP stops the pulse with slope, there may be still some pulses; in
this case, if run SBGOON K1 K0 again, it will output the rest of the pulses.
9-7 BLOCK flag bit and register
1. BLOCK flag bit:
2. BLOCK flag register:
BLOCK1 running instruction
BLOCK use this value when
monitoring
BLOCK2 running instruction
BLOCK3 running instruction
BLOCK100 running
instruction
If GBLOCK is used, it will occupy SM399 and SD399.
tudonghoatoancau.com
To Next Page
Loading...