Xinje XDH Series - 4-3-3 Flow [SET], [ST], [STL], [STLE]

88
If X0=ON, the program executes as the arrow.
If X0=OFF, the CALL instruction will not work; only the main program works.
The notes to write the subprogram:
Please programming the tag after FEND. Pn is the start of subprogram; SRET is the end of
subprogram. CALL Pn is used to call the subprogram. The range of n is 0 to 9999.
The subprogram calling can simplify the programming. If the program will be used in many
places, make the program in subprogram and call it.
4-3-3 Flow [SET], [ST], [STL], [STLE]
1)Summary
Instructions to specify the start, end, open, close of a flow;
Open the specified flow, close the local flow [SET]
16 bits
SET
32 bits
-
Execution
condition
Normally ON/OFF,
Rising/Falling edge
Suitable
Models
XD, XL
Hardware
requirement
-
Software
requirement
-
Open the specified flow, not close the local flow [ST]
16 bits
ST
32 bits
-
Execution
condition
Normally ON/OFF,
Rising/Falling edge
Suitable
Models
XD, XL
Hardware
requirement
-
Software
requirement
-
Flow starts [STL]
16 bits
STL
32 bits
-
Execution
condition
-
Suitable
Models
XD, XL
Hardware
requirement
-
Software
requirement
-
Flow ends [STLE]
16 bits
STLE
32 bits
-
Execution
condition
-
Suitable
Models
XD, XL
Hardware
requirement
-
Software
requirement
-
2)Operands
Operands
Function
Data Type
Sn
Jump to the target flow S
Flow No.
3)Suitable Soft Components
Operan
ds
Word soft elements
Bit soft elements
System
Consta
nt
Module
System
D
F
D
T
D
C
D
D
X
D
Y
D
M
D
S
K/H
I
D
Q
D
X
Y
M
S
T
C
Dn.
m
Sn
●
tudonghoatoancau.com