Xinje XDH Series User Manual

170
Compare the source data with the range
EZCP D10 D20 D0
M3
M4
M5
X0
S1· S2·
M3
S3·
D·
 Compare the source data S3 to the upper and lower limit value of the range S1~S2.
 The result will store in three coils starting from D.
 Constant K and H will transform to binary floating value when they are source data.
EZCP K10 K2800 D5 M0
X0
Note: the compare value must be floating numbers, otherwise the result will be error.
4-9-3 Floating Addition[EADD,EDADD]
1) Summary
Floating Add [EADD, EDADD]
16 bits
-
32 bits
EADD
Execution
condition
Normally ON/OFF,
rising/falling edge
Suitable
Models
XD, XL
Hardware
requirement
-
Software
requirement
-
64 bits
EDADD
Execution
condition
Normal ON/OFF/falling or
rising pulse edge
Suitable
Models
XDH, XLH
Hardware
requirement
Version V3.7.1 or later
Software
requirement
Version V3.7.4a or later
2) Operands
Description
(D1, D0) < (D11, D10) ON
Binary Floating Binary Floating
(D11, D10) ≤ (D1, D0 ) ≤ (D21, D20) ON
Binary Floating Binary Floating Binary Floating
(D1, D0) > (D21, D20) ON
Binary Floating Binary Floating
When X0 is OFF, even EZCP doesn’t run, M3~M5 will keep
the status before X0 is OFF.
(K10) : [D6,D5] : (K2800) → M0, M1, M2
Binary converts Binary Floating Binary converts
to Floating to Floating
Please set S1≤S2, when S2< S1, make S2 as the same value to S1.
tudonghoatoancau.com

Xinje XDH Series Specifications

General

Brand	Xinje
Model	XDH Series
Category	Network Hardware
Language	English