EasyManuals Logo

Xinje XDH Series User Manual

Xinje XDH Series
456 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
76
3-16 [GROUP] , [GROUPE]
GROUP and GROUPE should use in pairs.
GROUP and GROUPE don't have practical meaning; they are used to optimize the program
structure. So, add or delete these instructions doesn't affect the program's running;
The using method of GROUP and GROUPE is similar with flow instructions; enter GROUP
instruction at the beginning of group part; enter GROUPE instruction at the end of group part.
3-17 Programming notes
Contactor structure and steps
Even in the sequencial control circuit with the same function, it’s also available to simplify
the program and shorten the program steps according to the contactors structure. General
programming principle is: (a) write the circuit with many serial contacts on the top; (b) write
the circuit with many parallel contactors in the left.
Program’s executing sequence
Handle the sequencial control program by
From top to bottom
and
From left to right
Sequencial control instructions also encode following this procedure.
Dual output dual coil’s activation and the solution
Mnemonic
Function
Format and Device
GROUP
GROUP
Devices: None
GROUPE
GROUP END
Devices: None
Generally, GROUP and GROUPE
instruction can be programmed according
to the group's function. Meantime, the
programmed instructions can be FOLDED
or UNFOLDED. To a redundant project,
these two instructions are quite useful.
Statements
Mnemonic and Function
tudonghoatoancau.com

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xinje XDH Series and is the answer not in the manual?

Xinje XDH Series Specifications

General IconGeneral
BrandXinje
ModelXDH Series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals