5.2 European Standards
266 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
A - SW (ON) B - Screw (OFF)
Figure 5.16 EMC Filter Switch Location 7
If you lose an EMC filter switch screw, use Table 5.11 to find the correct replacement screw and install the new
screws with the correct tightening torque.
NOTICE: Only use the screws specified in this manual. If you use screws that are not approved, it can cause damage to the drive.
Table 5.11 Screw Sizes and Tightening Torques
Model Screw Size
Tightening Torque
N∙m
2004 - 2082, 4002 - 4060 M4 × 20
1.0 - 1.3
2110 - 2211, 4075 - 4168 M4 × 25
1.0 - 1.3
2257 - 2415, 4208 - 4720 M5 × 25 2.0 - 2.5
■ Installing the External EMC Noise Filter
Drive models 2xxxA and 4xxxA must meet conditions in this section to comply with EN 61800-3:2004+A1:2012.
Connect an EMC noise filter that complies with European standards as specified by Yaskawa to the input side
(primary side). Refer to External EMC Noise Filter Selection on page 269 to select the correct EMC noise filter.
Use this procedure to install an EMC noise filter to make equipment and devices added to the drive comply with the
EMC Directive.
1. Install the drive and EMC noise filter on the same grounded metal plate.
2. Wire the drive and motor.
3. Ground the wire shielding on the drive side and motor side.
A - Drive
B - 10 m (32.8 ft) maximum
C - Motor
D - Metal conduit
E - Grounding wire
Figure 5.17 Wiring the Drive and Motor
To Next Page
Loading...
