11.10 H: Terminal Functions
592 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
Setting Value Function Description Ref.
10B !Overheat Alarm (oH2)
Sets the drive to display an oH2 [Drive Overheat Warning] alarm when the input terminal deactivates. The alarm does
not have an effect on drive operation.
904
10C !Analog Terminal Enable
Selection
Enables and disables the terminal selected with the H3-14 [Analog Input Term Enable Select] function.
ON : Input to the terminal selected with H3-14 is disabled
OFF : Input to the terminal selected with H3-14 is enabled
904
10D !Ignore Speed Fdbk (V/f
w/o Enc)
When the terminal deactivates, the drive ignores the feedback control from the encoder and operates in V/f control.
When the terminal activates, the drive uses the feedback from the encoder to control the motor speed again.
ON : Speed feedback control enable (Closed Loop V/f Control)
OFF : Speed feedback control disable (V/f Control)
904
10E !ASR Integral Reset
Sets the command to reset the integral value and use PI control or P control for the speed control loop.
ON : PI control
OFF : P control
904
110 !Up Command
Set this function and 111 [! Down Command] together. Sets the Up command and Down command to use the two push
button switches to increase and decrease the drive frequency reference.
ON : Holds the current frequency reference.
OFF : Increases the frequency reference.
904
111 !Down Command
Set this function and 110 [!Up Command] together. Sets the Up command and Down command to use the two push
button switches to increase and decrease the drive frequency reference.
ON : Holds the current frequency reference.
OFF : Decreases the frequency reference.
904
114 !Fault Reset
Sets the command to reset the current fault when the Run command is not active.
Note:
The drive ignores the fault reset command when the Run command is active. Remove the Run command before
you try to reset a fault.
904
116 !Motor 2 Selection
Switches between motor 1 or motor 2. Switch the motor while the motor is stopped.
ON : Selects motor 1
OFF : Selects motor 2
904
118 !Timer Function
Sets the command to start the timer function. Use this setting with H2-xx = 112 [!Timer Output].
904
119 !PID Disable
Sets the command to disable PID control with an external input when b5-01 = 1 to 8 [PID Function Setting =
Enabled].
ON : PID control enabled
OFF : PID control disabled
904
11A !Accel/Decel Time
Selection 2
Set this function and H1-xx = 107 [!Accel/Decel Time Selection 1] together. Sets the drive to use C1-01 to C1-08
[Acceleration/Deceleration Times 1 to 4].
904
11B !Programming Lockout
Sets the command to prevent parameter changes when the terminal is OFF. You can continue to view parameter setting
values when the terminal is ON [Parameter Write Prohibit].
ON : Parameter Write Prohibit
OFF : Programming Lockout
904
11E !Reference Sample Hold
Samples the analog frequency reference input to the terminals A1, A2, or A3, and continues operation at the sampled
frequency.
904
130 !PID Integrator Reset
Sets the command to reset and hold the PID control integral to 0 when the terminal deactivates.
904
131 !PID Integrator Hold
Sets the command to hold the integral value of the PID control while the terminal deactivates.
904
132 !Multi-Step Speed
Reference 4
Uses a combination of multi-step speed references 1, 2 and 3 (N.C.) to switch d1-09 to d1-16 [Reference 9 to 16].
904
To Next Page
Loading...
