12.7 F: Options
858 YASKAWA SIEPC71061737D GA800 Drive Technical Reference
■ F5-03: Terminal P3-PC Function Select
No.
(Hex.)
Name Description
Default
(Range)
F5-03
(039B)
Terminal P3-PC Function
Select
Sets the function of terminal P3-PC on the DO-A3 option. Set F5-09 = 2 [DO-A3 Output Mode
Selection = Programmable (F5-01 to F5-08)] to enable this function.
2
(0 - 1A7)
■ F5-04: Terminal P4-PC Function Select
No.
(Hex.)
Name Description
Default
(Range)
F5-04
(039C)
Terminal P4-PC Function
Select
Sets the function of terminal P4-PC on the DO-A3 option. Set F5-09 = 2 [DO-A3 Output Mode
Selection = Programmable (F5-01 to F5-08)] to enable this function.
4
(0 - 1A7)
■ F5-05: Terminal P5-PC Function Select
No.
(Hex.)
Name Description
Default
(Range)
F5-05
(039D)
Terminal P5-PC Function
Select
Sets the function of terminal P5-PC on the DO-A3 option. Set F5-09 = 2 [DO-A3 Output Mode
Selection = Programmable (F5-01 to F5-08)] to enable this function.
6
(0 - 1A7)
■ F5-06: Terminal P6-PC Function Select
No.
(Hex.)
Name Description
Default
(Range)
F5-06
(039E)
Terminal P6-PC Function
Select
Sets the function of terminal P6-PC on the DO-A3 option. Set F5-09 = 2 [DO-A3 Output Mode
Selection = Programmable (F5-01 to F5-08)] to enable this function.
37
(0 - 1A7)
■ F5-07: Terminal M1-M2 Function Select
No.
(Hex.)
Name Description
Default
(Range)
F5-07
(039F)
Terminal M1-M2 Function
Select
Sets the function of terminal M3-M2 on the DO-A3 option. Set F5-09 = 2 [DO-A3 Output Mode
Selection = Programmable (F5-01 to F5-08)] to enable this function.
F
(0 - 1A7)
■ F5-08: Terminal M3-M4 Function Select
No.
(Hex.)
Name Description
Default
(Range)
F5-08
(03A0)
Terminal M3-M4 Function
Select
Sets the function of terminal M3-M4 on the DO-A3 option. Set F5-09 = 2 [DO-A3 Output Mode
Selection = Programmable (F5-01 to F5-08)] to enable this function.
F
(0 - 1A7)
■ F5-09: DO-A3 Output Mode Selection
No.
(Hex.)
Name Description
Default
(Range)
F5-09
(03A1)
DO-A3 Output Mode
Selection
Sets the output mode of signals from the DO-A3 option.
0
(0 - 2)
Refer to Table 12.45 for more information.
0 : Predefined Individual Outputs
1 : Binary Output
2 : Programmable (F5-01 to F5-08)
To Next Page
Loading...
