YASKAWA J1000 Technical Manual

E.2 Basic Parameter Settings
Use
the following tables to keep records of the most important parameters. Have these data available when contacting Yaskawa
technical support.
u
Basic Setup
Item Setting Value Memo
Control Mode A1-02 =
Normal/Heavy Duty Selection C6-01 =
Frequency Reference Source b1-01 =
Run Command Source b1-02 =
u
V/f Pattern Setup
Item Setting Value Memo
V/f Pattern Selection E1-03 =
Maximum Output Frequency E1-04 =
Maximum Voltage E1-05 =
Base Frequency E1-06 =
Middle Output Frequency E1-07 =
Mid. Output Freq. Voltage E1-08 =
Minimum Output Frequency E1-09 =
Min. Output Freq. Voltage E1-10 =
u
Motor Setup
Item Setting Value Memo
Motor Rated Current E2-01 =
Motor Rated Slip E2-02 =
Motor No-Load Current E2-03 =
Line-to-Line Resistance E2-05 =
u
Multi-Function Digital Outputs (MC Common)
Terminal
Used/
Reserved
Setting Value and Function Name Memo
MA-MB H2-01 =
u
Monitor Outputs (AC Common)
Terminal
Used/
Reserved
Setting Value and Function Name Memo
AM H4-01 =
E.2 Basic Parameter Settings
YASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual
249
E
Quick Reference Sheet
http://nicontrols.com

YASKAWA J1000 Specifications

General

Series	J1000
Voltage Class	200V, 400V
Frequency	50/60 Hz
Enclosure Rating	IP20
Enclosure Type	Open type
Voltage	200-240V, 380-480V
Control Method	V/f control
Overload Capacity	150% for 60 seconds
Protection	Overcurrent, Overvoltage, Undervoltage, Overheat, Ground Fault, Short Circuit
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Humidity	5-95% (non-condensing)
Enclosure	IP20
Input Voltage	200-240V, 380-480V