Electrical Installation
This chapter explains proper procedures for wiring the control circuit terminals, motor and power
supply.
3.1
SECTION SAFETY.................................................................................................32
3.2 STANDARD CONNECTION DIAGRAM.................................................................34
3.3 MAIN CIRCUIT CONNECTION DIAGRAM............................................................36
3.4 TERMINAL BLOCK CONFIGURATION................................................................37
3.5 PROTECTIVE COVERS.........................................................................................38
3.6 MAIN CIRCUIT WIRING.........................................................................................39
3.7 CONTROL CIRCUIT WIRING................................................................................43
3.8 I/O CONNECTIONS................................................................................................47
3.9 MAIN FREQUENCY REFERENCE........................................................................49
3.10 BRAKING RESISTOR............................................................................................50
3.11 INTERLOCKING WITH CONNECTED MACHINERY............................................52
3.12 WIRING CHECKLIST.............................................................................................53
3
YASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual
31
http://nicontrols.com
To Next Page
Loading...
Need help?
General
