Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
166
Parameters
Permitted
Values
Default
0-Disabled (power indicator LED does not flash)
1-Enabled (power indicator LED slowly flashes (1000ms) red)
For SIP-T19(P) E2 IP phones:
0-Disabled (power indicator LED does not flash)
1-Enabled (power indicator LED slowly flashes (1000ms) yellow)
Web User Interface:
Features->Power LED->MissCall Power Light Flash
Phone User Interface:
None
To configure the power Indicator LED via web user interface:
1. Click on Features->Power LED.
2. Select the desired value from the pull-down list of Common Power Light On.
3. Select the desired value from the pull-down list of Ringing Power Light Flash.
4. Select the desired value from the pull-down list of Voice/Text Mail Power Light Flash.
5. Select the desired value from the pull-down list of Mute Power Light Flash.
6. Select the desired value from the pull-down list of Hold/Held Power Light Flash.
7. Select the desired value from the pull-down list of Talk/Dial Power Light On.
8. Select the desired value from the pull-down list of MissCall Power Light Flash.
9. Click Confirm to accept the change.