Yealink SIP-T2 Series

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
216
Parameters
Permitted
Values
Default
If it is set to 1 (Enabled), the IP phone will transfer a call by automatically selecting a new line
key (the corresponding line key is not seized) instead of the current line key. If all line keys
are seized, the current line key will be used.
Note: The number of the line keys is determined by the value of the parameter
“account.X.number_of_linekey”. The value configured by the parameter
“account.X.phone_setting.call_appearance.transfer_via_new_linekey” takes precedence over
that configured by this parameter. It is not applicable to SIP-T19(P) E2 IP phones.
Web User Interface:
None
Phone User Interface:
None
phone_setting.call_appearance.conference_via_new_linekey
0 or 1
1
Description:
Enables or disables the IP phone to set up a conference call using a new line key when
multiple line keys are associated with an account.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the IP phone will place a new call using the current line key when
pressing the Conf/Conference soft key.
If it is set to 1 (Enabled), the IP phone will place a new call by automatically selecting a new
line key (the corresponding line key is not seized) when pressing the Conf/Conference soft
key. If all line keys are seized, the current line key will be used.
Note: The number of the line keys is determined by the value of the parameter
“account.X.number_of_linekey”. The value configured by the parameter
“account.X.phone_setting.call_appearance.conference_via_new_linekey” takes precedence
over that configured by this parameter. It is not applicable to SIP-T19(P) E2 IP phones.
Web User Interface:
None
Phone User Interface:
None