Yealink SIP-T2 Series - Page 302

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
278
=settings-dialplan&q=load
Details of Configuration Parameters:
Parameters
Permitted Values
Default
dialplan.replace.prefix.X
(X ranges from 1 to 100)
String within 32 characters
Blank
Description:
Configures the entered number to be replaced.
Example:
dialplan.replace.prefix.1 = 1
Note: It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Web User Interface:
Settings->Dial Plan->Replace Rule->Prefix
Phone User Interface:
None
dialplan.replace.replace.X
(X ranges from 1 to 100)
String within 32 characters
Blank
Description:
Configures the alternate number to replace the entered number.
Example:
dialplan.replace.prefix.1 =1 and dialplan.replace.replace.1 = 254245
When you enter the number ”1” and press the send key, the number “254245” will replace
the entered number “1”.
Note: It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Web User Interface:
Settings->Dial Plan->Replace Rule->Replace
Phone User Interface:
None
dialplan.replace.line_id.X
(X ranges from 1 to 100)
Refer to the following content
Blank (for
all lines)
Description:
Configures the desired line to apply the replace rule. The digit 0 stands for all lines. If it is left
blank, the replace rule will apply to all lines on the IP phone.