Configuring Basic Features
279
Permitted Values:
0 to 16 (for SIP-T48G/T48S/T46G/T46S/T29G)
0 to 12 (for SIP-T42G/S)
0 to 6 (for SIP-T41P/T41S/T27P/T27G)
0 to 3 (for SIP-T40P/T40G/T23P/T23G)
0 to 2 (for SIP-T21(P) E2)
Example:
dialplan.replace.line_id.1 = 1,2
Note: Multiple line IDs are separated by commas. It is not applicable to SIP-T19(P) E2 IP
phones. It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Web User Interface:
Settings->Dial Plan->Replace Rule->Account
Phone User Interface:
None
To create a replace rule via web user interface:
1. Click on Settings->Dial Plan->Replace Rule.
2. Enter the string in the Prefix field.
3. Enter the string in the Replace field.
4. Enter the desired line ID in the Account field or leave it blank.
If you leave this field blank or enter 0, the replace rule will apply to all accounts on the IP
phone.
5. Click Add to add the replace rule.
To Next Page
Loading...
Need help?
General
